[Social Robotics] [default] No working driver for Fanuc Robotics?

classic Classic
Reply |
Report Content as Inappropriate

[Social Robotics] [default] No working driver for Fanuc Robotics?

Sethu Vijayakumar
Hello,

I have serious problems with data transfer between my iX T15b panel, and the Fanuc Robot controller 30iB. Digital I/O works well, but data registers are not working properly. (driver GE/Fanuc Ethernet via SRTP) 
Problem 1: It´s not possible to send decimal values. The values will be rounded up/down to closest number. This causes lot of problems.
Problem 2: Data registers cannot be more than 4 digits. This is very big problem. Register handling will be unusable! Answers on that from Beijer? Is this driver tested with Fanuc Robots? Fanuc support says that this must be caused by the driver (GE Fanuc is an old PLC system, and shall not be compared and not simlilar to Fanuc Robotics)

Any help will be apprecited.

I didn't find the right solution from the Internet.

References:
http://beijerinc.com/support/ix/forum/viewtopic.php?f=5&t=1839

Thank you.
Loading...
1